화학공학소재연구정보센터
Polymer(Korea), Vol.34, No.5, 430-433, September, 2010
리튬이온 전지용 가스켓 고무의 특성에 미치는 충전제의 영향
The Effect of Fillers on Rubber Characteristics for Gasket to Lithium Ion Battery
E-mail:
초록
리튬이온 전지에 사용되는 가스켓 재료는 내전해액성, 전기절연성, 압축 영구 줄음률, 비오염성, 저온성이 요구된다. 가스켓 고무에 적용되는 충전제의 특성을 살펴보기 위하여 EPDM(ethylene propylene diene monomer), NBR(nitrile butadiene), FKM(fluoro elastomers)에 카본블랙 및 실리카계 충전제의 함량을 조정하여 compoud를 만들었다. 이렇게 배합된 compound를 리튬이온 전지의 작동 환경을 고려하여 전해액에 대한 장기평가 및 압축 영구 줄음률, 저온성에 대한 평가를 실시하였다. 본 실험에서는 카본블랙 및 실리카계 충전제를 사용하여 각 충전제에 따른 고무재료의 물리적 화학적 특성에 대하여 검토하였다.
The gasket materials of for the lithium ion battery requires chemical resistance to electrolyte, electrical insulating, compression set, anti-contamination and low temperature property. To check the special characteristics of fillers which are applied to rubber for gasket, compound of EPDM, NBR and FKM (fluoro elastomer) were made by adjusting weights of carbon black and silica additive. Using these compounds, we had done tests of long-term stability against electrolyte, compression set and low-temperature property with considering operating condition of the lithium ion battery. From this test, we investigated the physical and chemical characteristics of rubber with using of carbon black and silica additive in each.
  1. Kim HK, Na SC, New Renewable Energy and Fuel Cell, Haksul Intelligence (2006)
  2. Altair Nanotechnologies, U.S. Patent 60, 909, 361 (2008)
  3. Son JT, Bulletin of the Korean Institute of Electrical and Electronic Material Engineers, 22, 6 (2009)
  4. Kim J, Cho JC, Kwak S, Kim KU, Polym. Sci. Technol., 8(6), 700 (1997)
  5. Cooper W, “Synthetic Elastomers”, in Encyclopedia of Polymer Science and Technology, John Wiley & Sons, Inc., Vol 5, p.406 (1996)
  6. Freudenberg Process Seals, Sealing Technol., 12, 5 (2009)
  7. Aroguz A, J. Microsc., 232, 3 (2008)
  8. EPDM Technical information, Kumho Polychem Co.
  9. Duan H, China Elastomer, 18, 6 (2008)
  10. Kim MS, Kim JK, Elastomer, 42, 1 (2007)
  11. Trelleborg Sealing Solutions, Sealing Technol., 9, 3 (2009)
  12. Farrow P, Merli F, Sealing Technol., 1, 8 (2010)