화학공학소재연구정보센터
Applied Surface Science, Vol.256, No.3, 797-804, 2009
Microstructure and corrosion resistance of the layers formed on the surface of precipitation hardenable plastic mold steel by plasma-nitriding
Plasma-nitriding is used to improve the wear resistance and corrosion resistance of plastic mold steels by modifying the surface layers of these steels. In this study, a precipitation hardenable plastic mold steel (NAK80) was plasma-nitrided at 470, 500, and 530 degrees C for 4, 8, and 12 h under 25% N-2 + 75% H-2 atmosphere in an industrial nitriding facility. The microstructures of the base material and nitrided layers as well as the core hardness were examined, and various phases present were determined by X-ray diffraction. The corrosion behaviors were evaluated using anodic polarization tests and salt fog spray tests in 3.5% NaCl solution. The results had shown that plasma-nitriding does not cause the core to soften by overaging. Nitriding and aging could be achieved simultaneously in the same treatment cycle. Plasma-nitriding of NAK80 mold steel produced a nitrided layer composed of an outer compound layer constituting a mixture of epsilon-nitride and gamma'-nitride and an adjacent nitrogen diffusion layer on the steel surface. The amount of epsilon-nitride and total nitrides increased with an increase in nitriding temperature and nitriding time. Corrosion study revealed that plasma-nitriding significantly improved the corrosion resistance in terms of corrosion potential, corrosion and pitting current density, and corrosion rate. This improvement was found to be directly related to the increase in the amount of epsilon-nitride at the surface, indicating the amount of epsilon-nitride controlling the corrosion resistance. (C) 2009 Elsevier B. V. All rights reserved.