화학공학소재연구정보센터
Applied Surface Science, Vol.255, No.20, 8470-8474, 2009
Effects of annealing in nitrogen atmosphere and HCl-etching on the photoluminescence spectra of spray-deposited CdS: In thin films
The aim of this work is to find the effect of processing on the photoluminescence (PL) of spray-deposited CdS: In thin films. So the PL spectra of the as-deposited, annealed and HCl-etched CdS: In thin films prepared by the spray pyrolysis (SP) technique were recorded at T = 23 K. The yellow and red bands were observed in the spectrum of the as-deposited film beside bands with weaker intensity in the infrared region. The PL signal was weakened by annealing in nitrogen atmosphere at T = 400 degrees C and HCl-etching. A deconvolution peak fit was established to find the effects of these treatments on the different bands. The spectrum of the as-deposited film was deconvoluted to 12 peaks, which were reduced to 6 peaks after both treatments. It was found that both treatments have approximately the same effects on the PL spectra; that is they removed most of the peaks and shoulders in the red and infrared regions and attenuated most of the peaks in the yellow region. Some peaks were blue-shifted after annealing which was explained by the growth of nanocrystallites due to the thermal stress that results from the different expansion coefficients of the film and the substrate. These changes were accompanied by a phase change from the mixed (cubic and hexagonal) phase to the hexagonal phase as shown in the X-ray diffractograms. (C) 2009 Published by Elsevier B. V.