화학공학소재연구정보센터
Applied Surface Science, Vol.254, No.15, 4552-4556, 2008
Microstructure and selected properties of hot-work tool steel with PVD coatings after laser surface treatment
The paper presents the effect of HPD laser treatment on the microstructure and selected properties of the PVD CrN, (Ti, Al) and Ti(C, N) coatings deposited onto hot-work tool steel substrates. The microstructure and surface topography of the investigated samples are characteristic of the diversified morphology connected with the applied laser beam power. Employment of laser beam at 0.7 kW power to the laser treatment of samples with Ti(C, N) coatings causes clear coating adhesion growth because of the diffusive processes induced by heat release. Because of the higher value of the (Ti, Al) N absorption coefficient one can state that the observed substrate materials change and finally coatings destruction in case of those samples is the most noticeable. The moderate effect of the laser beam treatment of the hot-work tool steel with the PVD coating was observed for CrN coatings. However, for laser beam power above 0.5 kW differences in the thermal expansion coefficients of the substrate materials and coatings generate coating crackings. (C) 2008 Elsevier B.V. All rights reserved.