화학공학소재연구정보센터
Applied Catalysis B: Environmental, Vol.89, No.1-2, 273-283, 2009
Synthesis, characterization and activity of photocatalytic sol-gel TiO2 powders and electrodes
The efficiency of photoelectrocatalytic processes is strongly influenced by the electrode type and synthesis procedure. This work reports the sol-gel synthesis and characterization of TiO2 and Fe-doped TiO2 powders and electrodes as a function of pH and preparation temperatures and the correlation of their photoelectrochernical properties with their activity for azo dye clecolourisation. pH is shown to be the variable that most influences the formation of the TiO2. crystalline phases, the photocurrents of the electrodes, and consequently their photocatalytic activity. Electrodes synthesized at low pH and heated at temperatures below similar to 600 degrees C show a significant increase in the photocurrent recorded in the presence of methanol. This is attributed to suppression of the charge recombination rather than to a conventional current-doubling mechanism. The photocatalytic activities of the electrodes show a good correlation with the photocurrent measured in the presence of methanol. The mechanistic implications of this correlation are discussed. Iron doping reduces the activity of the sol-gel electrodes for dye clecolourisation. This contrasts with previous results for bacteria disinfection, which is believed to proceed by a hydroxyl radical mechanism. Consequently, it may be that the behaviour of iron as recombination centres or as trapping sites that improve the separation charges may depend on whether the photoelectrocatalytic reaction proceeds by a hydroxyl radical mechanism, as was shown for deactivation of Escherichia coli or by direct holetransfer, as is suggested by the parallels between dye clecolouration and the electrode response to methanol that are reported in this paper. (C) 2009 Elsevier B.V. All rights reserved.