화학공학소재연구정보센터
Journal of Applied Polymer Science, Vol.105, No.6, 3462-3469, 2007
Compressive response and energy absorption of foam EPDM
Ethylene-propylene-diene terpolymer foam was prepared by two different processing routes. The microstructure and mechanical properties of the foams with wide relative density ranging from 0.11 to 0.62 have been studied via scanning electron microscopy and mechanical testing, respectively. Scanning electron microscopy shows that the foam with lower relative density has a unique bimodal cell size structure, which the larger cells inlay among the smaller cells, while the foam articles with higher relative density have thicker cell walls with few small cells. The compressive stress-strain curves show that the foam articles with lower relative density have three regimes: linear elastic, a wide slightly rising plateau, and densification, while the foam articles with higher relative density have only two regimes: the longer linear elastic and densification. The relative modulus increases with the increase in the relative density. The contribution of the gas trapped in the cell to the modulus could be neglected. The energy absorbed per unit volume is relationship with the permitted stress and the relative density. The efficiency and the ideality parameter were evaluated from the compressive stress-strain plots. The parameters were plotted against stress to obtain maximum efficiency and the maximum ideality region, which can be used for optimizing the choice for practical applications in cushioning and packaging. (C) 2007 Wiley Periodicals, Inc.