화학공학소재연구정보센터
Applied Surface Science, Vol.253, No.15, 6588-6594, 2007
The influence of laser-induced surface modifications on the backside etching process
Spectroscopic measurements in the UV/VIS region show reduced transmission through laser-induced backside wet etching (LIBWE) of fused silica. Absorption coefficients of up to 10(5) cm(-1) were calculated from the transmission measurements for a solid surface layer of about 50 mn. The temperatures near the interface caused by laser pulse absorption, which were analytically calculated using a new thermal model considering interface and liquid volume absorption, can reach 10(4) K at typical laser fluences. The high absorption coefficients and the extreme temperatures give evidence for an ablation-like process that is involved in the LIBWE process causing the etching of the modified near-surface region. The confinement of the ablation/etching process to the modified near-surface material region can account for the low etch rates observed in comparison to front-side ablation. (C) 2007 Elsevier B.V. All rights reserved.