화학공학소재연구정보센터
Applied Surface Science, Vol.252, No.23, 8277-8286, 2006
Dielectric properties of a hydrated sulfonated poly(styrene-ethylene/butylenes-styrene) triblock copolymer
The present study showed that sulfonated poly(styrene-ethylene/butylenes-styrene) (S-SEBS) triblock copolymer ionomers can be made to exhibit dielectric constants on the order of a hundreds thousand. Although they are too lossy at this point to use as dielectric materials in capacitors or as electrostrictive Maxwell effect transducer materials because of their high hydrogen ion conductivity, the results of these initial dielectric studies as a function of ion content were used to try to understand the effects of a polar plasticizer, water, on dielectric properties of the acid form of this ionomer. This was done before moving on to more tightly bound ions (rather than the hydrogen ions of the sulfonic acid groups used here) and to other polar, less mobile plasticizers (which also interact strongly with the ionic dipoles). The discovery of such high dielectric constants suggested the possibility that low dielectric loss versions of this type of polymer, as well as other members of the class known as ionomers, might find future applications as extremely high dielectric constant materials in capacitors or transducers. Experimental results for films with degrees of sulfonation on the order of 10% or more showed dielectric constants on the order of epsilon'similar to 100,000 but dielectric loss tangents near D = tan delta similar to 0.3, when the materials were exposed to high humidity conditions. Experiments to determine the effects of water content on the material's dielectric response showed that water can easily move into and out of the films studied and that this transport behavior is strongly correlated to the relative humidity of the environment and to the degree of sulfonation. Water content, in this case, was thus the primary consideration when attempting to understand the observed high dielectric constants in films with degree of sulfonation greater than 5.5%. However, vacuum-dried films were, also, examined and observed to exhibit a dielectric constant on the order of 2 until the degree of sulfonation was greater than 11%. Above this value, the dielectric constant increased by approximately 100% to a value on the order of 4. (c) 2005 Elsevier B.V All rights reserved.