화학공학소재연구정보센터
Applied Surface Science, Vol.242, No.3-4, 428-436, 2005
Photo-electron emission and atomic force microscopies of the hydrogen etched 6H-SiC(0001) surface and the initial growth of GaN and AlN
Photo-emission electron microscopy (PEEM) and atomic force microscopy (AFM) have been used to characterize the surfaces of hydrogen etched 6H-SiC(0 0 0 1) wafers and the microstructure of the initial stags of growth of GaN and AIN on these surfaces via molecular beam epitaxy. The PEEM images were obtained using a free electron laser as the photon source. A stepped structure was evident in these images of the surfaces etched at 1600-1700 degrees C for 15 min. Comparison with the AFM images revealed that emission was occurring from the intersection of the steps and the terraces. Images of the initial stages of deposition of the GaN thin films at 700 and 800 degrees C revealed three-dimensional island growth. The degree of coalescence of these films was dependent upon the step structure: regions containing steps having unit cell height exhibited complete or nearly complete coalescence; regions containing steps with half unit cell height showed voids in the films parallel to the steps. PEEM of the initial stages of growth of AIN revealed immediate nucleation and rapid coalescence during deposition at 900 degrees C, except in areas on the substrate surface containing steps having half unit cell height. Incomplete coalescence and pits were also observed in the latter areas. (c) 2004 Elsevier B.V. All rights reserved.