화학공학소재연구정보센터
Thin Solid Films, Vol.480, 486-490, 2005
Low-cost CIGS solar cells by paste coating and selenization
A simple process for the deposition of Cu(In,Ga)Se-2 (CIGS) absorber layers is described. A low-cost CIGS precursor paste deposited by simple and fast doctor blade technique is subsequently selenized under selenium vapour in a quartz tube at 10 mbar (10 min at 550 C). The precursor paste is prepared with metal chlorides and nitrates dissolved in alcohol. The solution is then mixed with a cellulose solution to adjust the viscosity for optimal deposition. The conversion of the precursor to the CIGS phase was confirmed by X-ray diffraction (XRD). Grain size and morphology were characterised with electron microscopy. A double-layer structure formed during selenization, with a GIGS layer on top of an amorphous carbon layer. Auger electron spectroscopy (AES) shows a decreasing Ga/In ratio from the carbon-CIGS interface towards the CIGS surface. The layer structure grown on Mo-coated glass substrates (conventional dc-sputtering) was processed to solar cells by depositing a US buffer layer (chemical bath deposition) and ZnO/ZnO:Al front contacts (conventional rf-sputtering). A maximum efficiency of 6.7% was achieved with approximately 0.5-mu m-thick absorber layers. Quantum efficiency measurements reveal photon absorption losses for the longer wavelengths, which are attributed to the thin layers. (c) 2004 Elsevier B.V. All rights reserved.