화학공학소재연구정보센터
Desalination, Vol.163, No.1-3, 273-279, 2004
Improving gas separation properties of polymeric membranes based on glassy polymers by gas phase fluorination
The application area of existing gas separation membranes is limited by commercially available polymers for their preparation. In many cases the separation selectivity of these polymers is not sufficient for effective separation processes. One of the ways to improve the separation effectivity of existing membranes from glassy polymers is gas phase fluorination. It is very important to note that this method can be successfully used for modification of polymeric films, different types of membranes (flat sheet and hollow fiber) and membrane modules. The hollow fibers produced from Matrimid 5218 in Twente University and a flat-sheet membrane from polyvinylthrimethilsilane (PVTMS) produced in Russia were investigated. The treatment of samples by fluorination was carried out in closed reactor at 20-22degreesC with gaseous mixtures of F-2/He of different composition. A gas mixture of different concentrations (2-10 vol.% of F-2) at 1 atm was used The time of fluorination was from 2 min to 265 min. The dependence of the structure of the PVTMS and Matrimid 5218 on gas phase fluorination by IR-spectroscopy and the influence of modification on membrane structure by SEM were studied. The productivity of He, CO2, N-2, and CH4 through the membranes modified at different conditions of fluorination was measured, and it was shown that it is possible to achieve a significant increase of He/CH4, CO2/CH4 and He/N-2 selectivity at high level He and CO2 productivity by this type of modification. Thus, modified membranes and membrane modules can be successfully used for separation of components of biogas in membrane contactors and selective membrane valves for extraction of He/Ne fraction from waste in the metallurgy industry and separation of natural gas components.