Chinese Journal of Chemical Engineering, Vol.28, No.2, 440-444, 2020
Lysozyme adsorption to cation exchanger derivatized by sequential modification of poly(ethylenimine)-Sepharose with succinic anhydride and ethanolamine: Effect of pH and ionic strength
In our previous work, a series of polyethylenimine (PEI)-derived cation exchangers were synthesized using PEIgrafted resin FF-PEI-L740 (ionic capacity, 740 mmol.L-1) as the basic resin to study lysozyme adsorption and chromatographic behavior. It was found that the resin with an ionic capacity of 630 mmol.L-1 (FF-PEI-CR630) possessed high adsorption performance towards lysozyme at 0-100 mmol.L-1 NaCl. Therefore, in this work, FF-PEI-CR630 was selected to study the influences of pH and ionic strength (IS) on protein adsorption and chromatographic behavior towards lysozyme. The increase of lysozyme adsorption capacity in the pH range of 6 to 10 was observed. However, the uptake rate decreased in the pH range of 6 to 8 and then remained essentially unchanged from pH 8 to pH 10. Increasing IS led to decreased protein adsorption capacity and increased uptake rate in different pH ranges. Besides, FF-PEI-CR630 maintained dynamic binding capacity as high as over 150 mg.ml(-1) at pH 8-10 without NaCl. The research has thus provided insight into the selection of proper pH and IS conditions for protein purification by using FF-PEI-CR630. (C) 2019 The Chemical Industry and Engineering Society of China. and Chemical Industry Press Co., Ltd. All rights reserved.