화학공학소재연구정보센터
Journal of the American Chemical Society, Vol.141, No.15, 6292-6301, 2019
Dual Photocatalytic Roles of Light: Charge Separation at the Band Gap and Heat via Localized Surface Plasmon Resonance To Convert CO2 into CO over Silver-Zirconium Oxide
Confirmation of (CO2)-C-13 photoconversion into a C-13-product is crucial to produce solar fuel. However, the total reactant and charge flow during the reaction is complex; therefore, the role of light during this reaction needs clarification. Here, we chose Ag-ZrO2 photocatalysts because beginning from adventitious C, negligible products are formed using them. The reactants, products, and intermediates at the surface were monitored via gas chromatography-mass spectrometry and FTIR, whereas the temperature of Ag was monitored via Debye-Waller factor obtained by in situ extended X-ray absorption fine structure. With exposure to (CO2)-C-13, H-2, and UV-visible light, (CO)-C-13 selectively formed, while 8.6% of the (CO)-C-12 mixed in the product due to the formation of C-12-bicarbonate species from air that exchanged with the (CO2)-C-13 gas-phase during a 2 h reaction. By choosing the light activation wavelength, the CO2 photoconversion contribution ratio was charge separated at the ZrO2 band gap (lambda < 248 nm): 70%, localized at the Ag surface plasmon resonance (LSPR) (330 < lambda < 580 nm): 28%, and characterized by a thermal energy of 295 K: 2%. LSPR at the Ag surface was converted to heat at temperatures of up to 392 K, which provided an efficient supply of activated H species to the bicarbonate species, combined with separated electrons and holes above the ZrO2, which generated CO at a rate of 0.66 mu mol h(-1) g(cat)(-1) with approximately zero order kinetics. Photoconversion of (CO2)-C-13 using moisture was also possible. Water photo-oxidation step above ZrO2 was rate-limited, and the side reactions that formed H-2 above the Ag were successfully suppressed instead to produce CO via the Mg2+ addition to trap CO2 at the surface.