화학공학소재연구정보센터
Thin Solid Films, Vol.669, 440-449, 2019
Room temperature ferromagnetism and its correlation to ferroelectricity of manganese embedded in lead zirco-titanate
Manganese is deposited at high temperature on (001) oriented ferroelectric lead zirco-titanate prepared in two different ways: sputter-annealed or just simply annealed in ultrahigh vacuum. Room temperature ferromagnetism (FM) is obtained for Mn deposited on sputter-annealed substrates, while for the other sample preparation a paramagnetic behaviour is obtained. Also, for the first case a clear inwards component of the polarization P( - ) is observed by X-ray photoelectron spectroscopy and piezoresponse force microscopy. Composition analysis evidenced formation of Pb vacancies in the case of FM - P(( - ) )sample, consistent with hole formation near the surface, needed both to stabilize the inwards polarization state and to intermediate ferromagnetism between Mn2+ ions. The indirect exchange ferromagnetism mediated by holes is stronger, most probably because the interaction energy is proportional with the carrier effective mass. Also, whereas in the case of unsputtered substrate a stable surface Mn oxide is formed, defect formation by sputtering seems to favor Mn migration inside the sample. This also induces the formation of a thin film where ferromagnetism and the orientation of ferroelectric polarization might have the same origin, i. e. holes accumulated near the outer surface.