화학공학소재연구정보센터
Advanced Powder Technology, Vol.30, No.3, 656-671, 2019
Large eddy simulation of particle deposition and resuspension in turbulent duct flows
Particle deposition and resuspension in a horizontal, fully developed turbulent square duct flow at four flow bulk Reynolds numbers (10,320, 83k, 215k and 250k) is simulated by applying large eddy simulation coupled with Lagrangian particle tracking technique. Forces acting on particles includes drag, lift, buoyancy and gravity. Four particle sizes are considered with the diameters of 5 mu m, 50 mu m, 100 mu m and 500 mu m. Results obtained for the fluid phase are in good agreement with the available experimental and numerical data. Predictions for particles show that particle size, flow Reynolds number and the duct (celling, floor and vertical) walls play important roles in near-wall particle deposition and resuspension. For the smallest particle (5 mu m), the particle deposition rates in duct ceiling, floor and vertical walls are found to be similar with each other and all increase with the flow Reynolds number, while the particle resuspension tends to occur in the middle wall regions and corners of the duct with less influenced by the flow Reynolds number. The ceiling deposition rate gradually decreases with particle size while the floor and vertical wall deposition rates both increase with particle size. The ceiling particle deposition rate increases with Reynolds number while the floor deposition rate decreases with it. The vertical deposition rate for the small particles (5-50 mu m) increases with the flow Reynolds number obviously, while for the large particles (100-500 mu m) that becomes insensitive. In addition, the flow Reynolds number is found to have an obvious effect on particle resuspension while the effect of particle size on particle resuspension decreases with Reynolds number. Eventually, a dynamic analysis was conducted for particles deposition and resuspension in turbulent duct flows. (C) 2019 The Society of Powder Technology Japan. Published by Elsevier B.V. and The Society of Powder Technology Japan.