화학공학소재연구정보센터
Journal of Aerosol Science, Vol.126, 33-46, 2018
Mechanical stability measurements of surface modified nanoparticle agglomerates
A low pressure impactor is used to measure the mechanical stability of nanoparticle agglomerates. The stability at different impaction velocities is quantified as changes in the projection area of agglomerate fragments deposited on TEM grids mounted on the impaction plate. Platinum particles produced in a spark discharge generator are used as model particles. The mechanical stability of unmodified Pt-agglomerates is compared with the ones of thermally pretreated and coated agglomerates. The coatings are produced in a plasma assisted chemical vapor deposition process using the post-discharge environment of a dielectric barrier discharge. The coating process allows the coating of particles with silica at ambient temperature and so minimizes structural changes of the agglomerates before impaction. The precursors utilized are tetraethyl orthosilicate for silica and hexamethyldisiloxane for silica-organic coatings. Both coatings improve the stability of the agglomerates as indicated by reduced structural changes during impaction. The silica-organic coating, which is applied at 200 degrees C, seems to prevent sinter-related changes to the particles, which is observed for the uncoated particles at this temperature. This is further corroborated by the deposition behavior of these coated particles, which resembles more that of the original particles at 24 degrees C. Furthermore, the rebound behavior of coated agglomerates impacting on the TEM grid is shown. It is found that a minority of the particles rebound back from the TEM grid into the gas, which occurs in parallel to the structural changes.