화학공학소재연구정보센터
Applied Surface Science, Vol.448, 341-350, 2018
Subsurface damages beneath fracture pits of reaction-bonded silicon carbide after ultra-precision grinding
This paper investigated the structural defects beneath the fracture area of 6H-SiC in reaction-bonded silicon carbide (RB-SiC) ceramics after ultra-precision grinding. The nano-indentation technique was used to evaluate the evolution of deformation behavior and find the critical transition condition among elastic, plastic and fracture. It was found that beneath the fracture pits, dislocations accompanied with microcracks (lateral and median) were the two types of subsurface damage. However, no amorphous phase was detected. In addition, a two-beam analysis confirmed that the dislocations were activated on basal < a > and dissociated into the Shockley partial dislocations in 6H-SiC particle. The following indentation experiments revealed that the existence dislocations in the ground subsurface should be occurred earlier than cleavage. These dislocations were the predominant yielding mechanism in 6H-SiC, which initiated at a shear stress of about 23.4-28.4 Gpa through a pop-in event on load-displacement curve. Afterwards, cracks emerged when the maximum tensile stress beneath the indenter increased to 31.6 GPa. It was identified that cracks could be activated under the intersection effect of non-uniform high density dislocations. Meanwhile, the blocking effect on sliding motion of dislocations caused by cross propagating dislocations, phase boundary and sintering agents play an important role in the evolution of fracture during grinding process. At last, the deformation behavior was further elaborated to discuss the slippage on the basal plane determined by Schmid factor and structure characteristic of 6H-SiC. (C) 2018 Elsevier B.V. All rights reserved.