화학공학소재연구정보센터
Energy, Vol.141, 2234-2241, 2017
Clean pyrolysis oil from a continuous two-stage pyrolysis of scrap tires using in-situ and ex-situ desulfurization
Scrap tire pyrolysis was conducted to produce low sulfur oil (below 0.45 wt%), which is strongly demanded for reduction of SOx emissions. In the experiments, a continuous two-stage pyrolyzer consisting of an auger reactor and fluidized bed reactor and various additives (CaO, Fe, FeO, calcined olivine) and fluidizing media (product gas and N-2) were tested for the in-situ desulfurization. The auger reactor operated at similar to 340 degrees C yielded a liquid with 3-5 wt.% of pyrolysis oil. The content of DL-limonene in this liquid product was similar to 51 wt% and increased further to similar to 76 wt% through subsequent ethanol extraction. The fluidized bed reactor (similar to 510 degrees C) produced pyrolysis oils with yields around 30-37 wt%. N-2 reduced the sulfur content in pyrolysis oil more effective than product gas, due to its dilution effect. The majority of tested desulfurizing additives reduced the sulfur content in pyrolysis oil, and the application of FeO powder and N-2 in particular produced pyrolysis oil with the lowest sulfur content (0.39 wt%). Two ex-situ desulfurization methods (ethanol extraction and oxidation/ethanol extraction) were tested to further reduce the sulfur content. The oxidation/ethanol extraction method decreased the content of sulfur in pyrolysis oil to 0.17 wt%. (C) 2017 Elsevier Ltd. All rights reserved.