화학공학소재연구정보센터
Electrochimica Acta, Vol.263, 299-310, 2018
Fabrication and characterization of porous, conductive, monolithic Ti4O7 electrodes
Highly porous and conductive monolithic electrodes have found various electrochemical applications in water treatment and energy storage and conversion. In this work we have successfully synthesized monolithic Ti4O7 electrodes by two production methods-mechanical pressing of Ti4O7 powders and gel casting of TiO2 powders followed by sintering and reduction to Ti4O7. The electrodes were characterized by X-ray diffraction (XRD), Hg porosimetry, scanning electron microscopy, thermal gravimetric analysis, Mott-Schottky analysis, and sweep voltammetry. The removal of oxygen atoms from the TiO2 precursor resulted in n-type doping behavior, and XRD measurements confirmed the electrodes consisted of high purity Ti4O7. Porosimetry analyses indicated the electrodes had high porosities (44-48%) and low bulk densities (similar to 2.0 g cm(-3)), which allowed for high permeate fluxes of up to 801 +/- 81 LMH bar(-1), when operated in a flow-through mode. The efficient mass transfer achieved in the porous electrodes resulted in high rate constants for the oxidation of Fe(CN)(6)(4) (k(obs) = 3.0-4.5 x 10(-4)ms(-1)). The electrodes also showed high rates of removal for oxalic acid and terephthalic acid, which were probes for direct oxidation and OH center dot production, respectively. Chemical etching of the electrodes increased the electro-active surface area by approximately 2-fold, which increased the capacitance (30 mF cm(-2)) and reactivity of the electrodes towards outer sphere electron transfer reactions and the production of OH center dot by the same factor. These results indicated that the Ti4O7 monolithic electrodes could enhance charge transfer reactions in various electrochemical applications. (c) 2018 Elsevier Ltd. All rights reserved.