화학공학소재연구정보센터
Fuel, Vol.203, 330-340, 2017
Intercomparison of ethanol, formaldehyde and acetaldehyde measurements from a flex-fuel vehicle exhaust during the WLTC
An intercomparison exercise of the world-harmonized light-duty vehicle test procedure (WLTP) aiming at measuring ethanol, formaldehyde and acetaldehyde emissions from a flex-fuel light-duty vehicle using E85 was conducted in the Vehicle Emission Laboratory (VELA) at the European Commission Joint Research Centre (EC-JRC), Ispra, Italy. The instruments used during the intercomparison allowed online measurements of these compounds directly from the diluted exhaust. Measurements were done either in real time or immediately after the test. The measurement and analysis of exhaust emissions over the world-harmonized light-duty vehicle test cycle was done by means of Fourier transform infrared spectroscopy (FTIR), proton transfer reaction-mass spectrometry (PTR-Qi-ToF-MS), photoacoustic spectroscopy (PAS) and gas chromatography (GC). Results showed that online systems can perform measurements from the vehicle diluted exhaust assuring a good repeatability (within instrument variance) and reproducibility (between instrument variance) of the results. Measurements from all the instruments were in good agreement (|Z-score| < 2). Results showed that online systems can perform measurements from the vehicle diluted exhaust assuring the reproducibility and repeatability of the results. Results obtained measuring at the tailpipe using a FTIR were in good agreement with those acquired measuring at the constant volume sampler (CVS). Considering the low sensitivity of the current technique used to measure hydrocarbons emissions towards oxygenated compounds (flame ionization detector; FID), non-methane organic gases (NMOG) were calculated applying their FID response factors to the measured emissions of ethanol, acetaldehyde and formaldehyde. NMOG resulted to be up to 74% higher than measured non-methane hydrocarbons (NMHC). (C) 2017 The Authors. Published by Elsevier Ltd.