Lamellar and pillared ZSM-5 materials modified with Mg and Zn oxides were synthesized and tested for in-situ catalytic upgrading of eucalyptus woodchips fast-pyrolysis vapors. The introduction of silica pillars into the lamellar ZSM-5 support led to a higher BET area, but also reduced the overall catalyst acidity. The incorporation of MgO and ZnO occurred with a high dispersion over the zeolitic supports, causing also a significant reduction in the value of their textural properties due to a partial blockage of the zeolite pores. Likewise, the acid features of the zeolitic supports underwent sharp changes by the addition of both MgO and ZnO with a strong decrease in the concentration of the Bronsted and Lewis acid sites present in the parent zeolite, as detected by pyridine adsorption followed FTIR spectroscopy. However, additional Lewis acid sites were created associated to the metal oxides deposited onto the zeolitic supports. Pyrolysis tests were accomplished using a lab-scale downdraft fixed-bed reactor working at atmospheric pressure and a temperature of 500 degrees C. The use of zeolitic catalysts increased the gas yield, mostly due to the formation of CO and CO2, to the detriment of bio-oil production. However, the so obtained bio-oils presented higher quality in terms of H/C and OC ratios, and larger heating values. The incorporation of MgO and ZnO allowed tailoring the zeolite activity to avoid an excessive cracking of the bio-oil, which in turn resulted in a higher yield of the organic compounds present in the bio-oil, and decreasing the formation of undesired polyaromatic hydrocarbons and coke. (C) 2016 Elsevier B.V. All rights reserved.