화학공학소재연구정보센터
Chemical Engineering Journal, Vol.290, 201-208, 2016
Electrochemical-catalytic reduction of nitrate over Pd-Cu/gamma Al2O3 catalyst in cathode chamber: Enhanced removal efficiency and N-2 selectivity
The Pd-Cu/gamma Al2O3 catalysts were prepared by impregnation method and introduced into the cathode chamber of a divided electrochemical denitrification cell with two graphite plates as the cathode and anode, to enhance the nitrate removal efficiency and N-2 selectivity. The Pd-Cu/gamma Al2O3 catalysts were characterized by transmission electron microscope (TEM), X-ray diffraction (XRD), specific surface area measurements (BET) and inductively coupled plasma-atomic emission spectrometry (ICP-AES). In the rationally designed electrochemical-catalytic (ECC) system, the as-prepared catalyst could significantly enhance the nitrate degradation rate to 1.08 ma at current density of 10 mA/cm(2), which was approx. 2.5 times compared with the electrochemical (EC) system without catalysts adding in. Additionally, a higher nitrogen selectivity of 80.37% was obtained under the same experiment condition. The improved performances were likely due to the presence of a catalytic reduction reaction of nitrate with the appropriate amount of hydrogen generated by electrolysis as reductant. Significantly, the current efficiency was calculated and enhanced value of 20-40% (depended on current density) was obtained in the ECC process with a catalyst content of 1.0 g/L. (C) 2016 Elsevier B.V. All rights reserved.