화학공학소재연구정보센터
Reactive & Functional Polymers, Vol.89, 40-48, 2015
Modifying polyester surfaces with incompatible polymer additives
Surface modification of amorphous PET in incompatible blends is demonstrated using fluorocarbon end-functional polystyrenes. Contact angles with water and decane were consistent with high levels of surface fluorocarbon, even for spin-cast films with no further processing required. Hydrophobicity and lipophobicity were further increased by annealing above the glass transition temperature. High resolution depth profiling using complementary ion beam analysis and specular neutron reflectometry has enabled accurate characterisation of the composition profile of the additive including the minimum in additive concentration found just below the surface enriched layer. This analysis quantified the very low compatibility between the modifying polymer and the amorphous PET and was consistent with the highly segregated nature of the adsorbing species and its sharp interface with the subphase. For these incompatible polymer blends, surfaces enriched with the surface active polymer could coexist at equilibrium with extremely low (similar to 0.4%) bulk loadings of the additive. This suggests that for thicker films at even lower additive concentrations than the minimum 1% that we studied, it may be possible to achieve efficient surface modification. However, at this concentration, the efficiency of surface modification is limited by the processing conditions. Finally we note that in higher loadings of surface active additive there is clear evidence for lateral phase separation into patterned domains of differing composition. The enhancement in surface properties is due to local reorganisation rather than bulk redistribution of the components within the film, as the composition versus depth distributions of the polymer blend components was observed to be relatively unaffected by annealing. (C) 2015 Elsevier B.V. All rights reserved.