화학공학소재연구정보센터
Korean Journal of Materials Research, Vol.22, No.10, 531-538, October, 2012
나노 실리카의 분무건조를 이용한 중공구 입자 제조와 실리카중공구의 열전달 특성
Preparation of Hollow Silica by Spray Drying of Nano Silica Particles and Its Heat Transfer Property
E-mail:
Hollow silica spheres were prepared by spray drying of precursor solution of colloidal silica. The precursor solution is composed of 10-20 nm colloidal silica dispersed in a water or ethanol-water mixture solvent with additives of tris hydroxymethyl aminomethane. The effect of pH and concentrations of the precursor and additives on the formation of hollow sphere particles was studied. The spray drying process parameters of the precursor feeding rate, inlet temperature, and gas flow rate are controlled to produce the hollow spherical silica. The mixed solvent of ethanol and water was preferred because it improved the hollowness of the spheres better than plain water did. It was possible to obtain hollow silica from high concentration of 14.3 wt% silica precursor with pH 3. The thermal conductivity and total solar reflectivity of the hollow silica sample was measured and compared with those values of other commercial insulating fillers of glass beads and TiO2 for applications of insulating paint, in which the glass beads are representative of the low thermal conductive fillers and the TiO2 is representative of infrared reflective fillers. The thermal conductivity of hollow silica was comparable to that of the glass beads and the total solar reflectivity was higher than that of TiO2.
  1. Wei M, Van Oers CJ, Hao X, Qiu Q, Cool P, Liu S, Microporous Mesoporous Mater., 138, 17 (2011)
  2. Wang AJ, Lu YP, Sun RX, Mater. Sci. Eng., 460-461, 1 (2007)
  3. Cochran JK, Curr. Opin. Solid State Mater. Sci., 3, 474 (1998)
  4. Caruso F, Caruso RA, Mohwald H, Science, 282(5391), 1111 (1998)
  5. Martinez CJ, Hockey B, Montgomery CB, Semancik S, Langmuir, 21(17), 7937 (2005)
  6. Yin W, Wang W, Shang M, Zhou L, Sun S, Wang L, Eur. J. Inorg. Chem., 2009, 4379 (2009)
  7. Sadasivan S, Sukhorukov GB, J. Colloid Interface Sci., 304(2), 437 (2006)
  8. Bamnolker H, Nitzan B, Gura S, Margel S, J. Mater. Sci. Lett., 16(16), 1412 (1997)
  9. Schacht S, Huo Q, Voigtmartin IG, Stucky GD, Schuth F, Science, 273(5276), 768 (1996)
  10. Kato T, Tashiro M, Sugimura K, Hyodo T, Shimizu Y, Egashira M, J. Ceram. Soc. Jpn., 110, 146 (2002)
  11. Qi XB, Gao C, Zhang ZW, Chen SF, Li B, Wei S, Int. J. Hydrog. Energy, 37(2), 1518 (2012)
  12. Deng ZW, Chen M, Zhou SX, You B, Wu LM, Langmuir, 22(14), 6403 (2006)
  13. Lu Y, McLellan J, Xia YN, Langmuir, 20(8), 3464 (2004)
  14. Cheow WS, Li S, Hadinoto K, Chem. Eng. Res. Des., 88(5-6A), 673 (2010)
  15. Luo P, Nieh TG, Biomaterials, 17, 1959 (1996)
  16. Luo P, Nieh TG, Mater. Sci. Eng. C, 3, 75 (1995)
  17. Cao XQ, Vassen R, Schwartz S, Jungen W, Tietz F, Stoever D, J. Eur. Ceram. Soc., 20, 2433 (2000)
  18. Hadinoto K, Phanapavudhikul P, Kewu Z, Tan RBH, Ind. Eng. Chem. Res., 45(10), 3697 (2006)
  19. Jeon J, Hwang S, Ahn J, Kim H, Korean J. Mater. Res., 19(8), 407 (2009)