화학공학소재연구정보센터
Journal of Membrane Science, Vol.442, 1-7, 2013
Effects of fabrication processes on oxygen permeation of Nb2O5-doped SrCo0.8Fe0.2O3-delta micro-tubular membranes
In this study, Nb2O5-doped (0.5 wt%) SrCo0.8Fe0.2O3-delta (SCFNb0.5), an oxide of perovskite structure that is chemically and structurally stable for oxygen separation between 550 and 900 degrees C [1], has been used to fabricate two types of micro-tubular membranes, i.e. an asymmetric hollow fibre membrane (SCFNb0.5-HF) and a symmetric capillary membrane (SCFNb0.5-C), using a combined phase inversion and sintering process and plastic extrusion method, respectively. The asymmetric SCFNb0.5-HF membrane is designed to consist of a thin and dense oxygen separation layer (approximately 62 mu m) supported on a porous finger-like layer (around 415 mu m) of the same material, with a highly porous inner surface for a significantly reduced mass transfer resistance during oxygen permeation. The separation layer of the symmetric SCFNb0.5-C is approximately 436 mu m. Besides characterizations on membrane structures, oxygen permeations of the two membranes were measured and compared, and linked to the effects of fabrication processes on membrane performance. Further suggestions are also outlined for the future fabrication of ceramic hollow fibre membranes using the combined phase inversion and sintering technique, especially when ceramic materials with complex compositions are employed. (C)) 2013 Elsevier B.V. All rights reserved.