화학공학소재연구정보센터
Journal of the Korean Industrial and Engineering Chemistry, Vol.9, No.5, 619-623, October, 1998
불화된 금속산화물 촉매상에서 이불화메탄의 합성
Difluoromethane Synthesis over Fluorinated Metal Oxide
초록
불화된 금속 산화물 촉매상에서 이염화메탄올을 불화하여 이불화메탄을 합성하는 연구를 하였다. 실험 변수는 반응온도, HF/DCM (dichloromethane) 몰비, 접촉시간 그리고 촉매의 형태이었다. 촉매의 성능은 불화된 알루미나 보다는 크롬이 담지된 불화된 알루미나가 우수하였으며 크롬을 담지한 촉매에서 전처리 하지 않은 경우가 수소와 공기 분위기로 소성처리한 경우보다 더욱 우수하였다. 최적 반응 조건은 반응온도 340℃, HF/DCM 몰비 5이상 그리고 접촉시간 20초 이상이었다. 이들 조건에서 얻은 이불화메탄의 최대 수율은 80% 이상이었다. 특히 반응시간이 8시간까지 촉매의 활성 감소나 이불화메탄의 선택성의 감소가 나타나지 않았다.
The influences of reaction temperature, HF/DCM mole ratio, contact time and catalyst type on activity and selectivity of difluoromethane synthesis via hydrofluoriation of dichloromethane over fluorinated catalyst have been studied. It has been found that fluorinated Cr/Al2O3 catalysts, show better performance compared to pure fluorinated Al2O3 catalyst and then, non-treated catalysts demonstrate better than catalysts pretreated with hydrogen and air. The results show that the optimum reaction conditions are found as follows : reaction temperature at 340℃, mole ratio of HF/DCM 5 or above and contact time 20 sec. or above. With these conditions the maximum attainable yield of difluoromethane has been found to be greater than 80%. In particular, the activity and the selectivity of difluoromethane do not change with the reaction time on stream up to 8 hours.
  1. Molina MJ, Rowland FS, Nature, 249, 810 (1974) 
  2. UNEP, "Montreal Protocol on Substances that Deplete the Ozone Layer," Final Act (1987)
  3. 이윤우, "CRC대체냉매에 대한 최신 동향," CRC 정보, 18, 2 (1996)
  4. 이윤우, "HCFC계 냉매규제에 따른 대체냉매개발," 냉동공조기술, 13(1), 47 (1996)
  5. Chabrie C, Compt. Rend, 110, 280 (1890)
  6. Midgley T, Henne AL, U.S. Patent, 2,013,062 (1935)
  7. 이윤우, "HFC-32의 합성반응연구," KIST 보고서 BSE1135-4767-6 (1993)
  8. 이윤용, 이윤우, "국내의 CFC대체냉매물질 개발," 공기조화 냉동공학, 21, 174 (1992)
  9. Ghosh AK, Kydd RA, Catal. Rev.-Sci. Eng., 27, 539 (1985)