화학공학소재연구정보센터
Applied Surface Science, Vol.286, 212-219, 2013
Plasma electrolytic oxidation of 2024-T3 aluminum alloy and investigation on microstructure and wear behavior
In this study, plasma electrolytic oxidation has been used to improve wear resistance of 2024-T3 aluminum alloy. An electrolyte containing available and inexpensive constituents was used. A conventional DC source with low applied voltage was employed. It was found that with increase in oxidation treatment time the micro-hardness of the coating were decreased while the friction coefficient increased. It was seen that deposition at optimum treatment time of 10 min resulted in the highest micro-hardness and lowest friction coefficient and weight loss. The surface and cross-sectional morphology indicated that the coatings have a dense structure with low porosity and without any cracking. Also, the presence of wear scars on the worn surface morphology demonstrates that the three-body rolling was the main wear mechanism for coated specimen. The phase analysis of the coating indicated that the coating was formed mainly from, alpha-Al2O3, x-Al2O3, Al-3.21 Si-0.42 and small amounts of amorphous phases. The presence of glycerin in the electrolyte composition resulted in not only stabilizing the solution but also achieving of a dense and uniform coating without any cracking. (C) 2013 Elsevier B.V. All rights reserved.