화학공학소재연구정보센터

Industrial & Engineering Chemistry Research

Industrial & Engineering Chemistry Research, Vol.47, No.8 Entire volume, number list
ISSN: 0888-5885 (Print) 

In this Issue (42 articles)

2455 - 2477 Review of fluid slip over superhydrophobic surfaces and its dependence on the contact angle
Voronov RS, Papavassiliou DV, Lee LL
2478 - 2483 Enhancement of the thermo- and photostability of an anionic dye by intercalation in a zinc-aluminum layered double hydroxide host
Tang PG, Xu XY, Lin YJ, Li DQ
2484 - 2494 Tandem synthesis of beta-amino alcohols from aniline, dialkyl carbonate, and ethylene glycol
Shivarkar AB, Gupte SP, Chaudhari RV
2495 - 2501 Fabrication of polysaccharide-inorganic hybrid biocapsules with improved catalytic activity and stability
Jiang YJ, Zhang L, Yang D, Li L, Zhang YF, Li J, Jiang ZY
2502 - 2510 Effect of structures and concentrations of softeners on the performance properties and durability to laundering of cotton fabrics
Reddy N, Salam A, Yang YQ
2511 - 2517 Industrial coke as an electrode material for environmental remediation
Haner J, Rankin K, Bejan D, Bunce NJ
2518 - 2522 Effect of chromate addition on the structure and kinetics of leaching for the formation of promoted skeletal (raney) cobalt catalysts
Smith AJ, Garciano LO, Tran T
2523 - 2527 Catalytic pathways identification for partial oxidation of methanol on copper-zinc catalysts: CH3OH+1/2O(2)<-> CO2+2H(2)
Lin YC, Fan LT, Shafie S, Hohn KL, Bertok B, Friedler F
2528 - 2537 Kinetic parameter estimation of a diesel oxidation catalyst under actual vehicle operating conditions
Wang TJ, Baek SW, Lee JH
2538 - 2544 MCM-48 supported tungstophosphoric acid: An efficient catalyst for the esterification of long-chain fatty acids and alcohols in supercritical carbon dioxide
Sakthivel A, Komura K, Sugi Y
2545 - 2553 Kinetics of ozone decomposition by granular activated carbon
Alvarez PM, Masa FJ, Jaramillo J, Beltran FJ, Gomez-Serrano V
2554 - 2560 Chemical kinetics of polymethyl methacrylate (PMMA) decomposition assessed by a microwave-assisted digestion system
Tsai TL, Lin CC, Guo GL, Chu TC
2561 - 2568 Investigation into nanoTiO(2)/ACSPCR for decomposition of aqueous hydroquinone
Geng QJ, Guo QJ, Cao CQ, Wang LT
2569 - 2578 Polymer-filled composite porous catalytic particles for hydrodynamic studies in trickle-bed reactors
Aydin B, Bilodeau S, Hamidipour M, Larachi F, Kleitz F
2579 - 2584 Experimental and kinetic studies of gas-phase pyrolysis of n-C4F10
Yu H, Kennedy EM, Ong WH, Mackie JC, Han WF, Dlugogorski BZ
2585 - 2589 Hydroformylation catalyst recycle with gas-expanded liquids
Hallett JP, Ford JW, Jones RS, Pollet P, Thomas CA, Liotta CL, Eckert CA
2590 - 2596 Crystallization behaviors of poly(ethylene 2,6-naphthalate) in the presence of liquid crystalline polymer
Gao X, Liu RG, Zhang J, Zhang JH
2597 - 2604 Beads mill-assisted synthesis of poly methyl methacrylate (PMMA)-TiO2 nanoparticle composites
Inkyo M, Tokunaga Y, Tahara T, Iwaki T, Iskandar F, Hogan CJ, Okuyama K
2605 - 2611 Pyrolysis of polymer-derived carbons in the formation of graphitizing carbons and nanoparticles of zirconia
Hudson MJ, Peckett JW, Sibley CS, Harris PJF
2612 - 2617 Effect of amphiphilic additives on the behavior of water-based acrylic pressure-sensitive adhesives during paper recycling
Guo J, Severtson SJ, Gwin LE, Houtman CJ
2618 - 2622 Preparation and characterization of macroporous carbonate-substituted hydroxyapatite scaffold
Lee Y, Hahm YM, Lee DH, Matsuya S, Nakagawa M, Ishikawa K
2623 - 2629 Effect of particle aggregation on the mechanical properties of a reinforced organic-inorganic hybrid sol-gel composite
Poovarodom S, Hosseinpour D, Berg JC
2630 - 2635 Influence of water on high-temperature CO2 capture using layered double hydroxide derivatives
Reddy MKR, Xu ZP, Lu GQ, da Costa JCD
2636 - 2642 Fault diagnosis and isolation of multi-input-multi-output networked control systems
Zhang YW, Sheng J, Qin SJ, Hesketh T
2643 - 2655 Global optimization of highly nonlinear dynamic systems
Flores-Tlacuahuac A, Moreno ST, Biegler LT
2656 - 2665 A computational transport model for wall-cooled catalytic reactor
Liu GB, Yu KT, Yuan XG, Liu CJ
2666 - 2680 A barrier-terrain methodology for global optimization
Lucia A, Gattupalli RR, Kulkarni K, Linninger A
2681 - 2695 Design and control of a fully heat-integrated pressure-swing azeotropic distillation system
Luyben WL
2696 - 2707 Comparison of extractive distillation and pressure-swing distillation for acetone-methanol separation
Luyben WL
2708 - 2720 Adaptive model predictive control of multivariable time-varying systems
Karra S, Shaw R, Patwardhan SC, Noronha S
2721 - 2727 Collective sliding-mode technique for multivariable bumpless transfer
Garelli F, Mantz RJ, De Battistao H
2728 - 2741 Parameter identification of a dynamic MCFC model using a full-scale fuel cell plant
Gundermann M, Heidebrecht P, Sundmacher K
2742 - 2761 Optimal equipment allocation for high plant flexibility: an industrial case study
Castro PM, Novais AQ, Carvalho A
2762 - 2777 Generic graphical technique for simultaneous targeting and design of water networks
Alwi SRW, Manan ZA
2778 - 2787 Steady-state multiplicity and its implications on the control of an ideal reactive distillation column
Kumar MVP, Kaistha N
2788 - 2793 Optimal control problem in batch distillation using thermodynamic efficiency
Zavala JC, Coronado C
2794 - 2802 Gas permeability properties of mixed-matrix matrimid membranes containing a carbon aerogel: A material with both micropores and mesopores
Zhang YF, Musselman IH, Ferraris JP, Balkus KJ
2803 - 2807 Extraction of trivalent lanthanides with oxa-diamides in supercritical fluid carbon dioxide
Tian GX, Liao WS, Wai CM, Rao LF
2808 - 2816 Singularities in reactive separation processes
Ruiz G, Diaz M, Sridhar LN
2817 - 2828 Numerical simulation of methane production from a methane hydrate formation
Liu Y, Strumendo M, Arastoopour H
2829 - 2841 Hydrodynamic and mass transfer characteristics of single and multiple impeller hollow self-inducing reactors
Kasundra RB, Kulkarni AV, Joshi JB
2842 - 2848 Two-layer binary tree data-driven model for valve stiction
Chen SL, Tan KK, Huang SA