화학공학소재연구정보센터

Energy

Energy, Vol.58 Entire volume, number list
ISSN: 0360-5442 (Print) 

In this Issue (72 articles)

1 - 1 ECOS 2012
Fiaschi D, Stevanovic VD, Zhang N
2 - 8 Alternative feedstock for the biodiesel and energy production: The OVEST project
Prussi M, Chiaramonti D, Recchia L, Martelli F, Guidotti F, Pari L
9 - 16 Thermo-economic evaluation and optimization of the thermo-chemical conversion of biomass into methanol
Peduzzi E, Tock L, Boissonnet G, Marechal F
17 - 27 Exergy analysis and optimisation of a steam methane pre-reforming system
Dimopoulos GG, Stefanatos IC, Kakalis NMP
28 - 35 Model to predict design parameters and performance curves of vacuum glass heat pipe solar collectors
Fiaschi D, Manfrida G
36 - 44 Low CO2-emissions hybrid solar combined-cycle power system with methane membrane reforming
Li YY, Zhang N, Cai RX
45 - 51 Thermo-economic assessment of a micro CHP system fuelled by geothermal and solar energy
Tempesti D, Fiaschi D
52 - 65 Application of the entropy generation minimization method to a solar heat exchanger: A pseudo-optimization design process based on the analysis of the local entropy generation maps
Giangaspero G, Sciubba E
66 - 77 Comparison study on different SOFC hybrid systems with zero-CO2 emission
Duan LQ, Huang KX, Zhang XY, Yang YP
78 - 85 Model of a small steam engine for renewable domestic CHP (combined heat and power) system
Ferrara G, Manfrida G, Pescioni A
86 - 96 Comparison of IGCC (integrated gasification combined cycle) and CFB (circulating fluidized bed) cogeneration plants equipped with CO2 removal
Liszka M, Malik T, Budnik M, Ziebik A
97 - 106 An Organic Rankine Cycle off-design model for the search of the optimal control strategy
Manente G, Toffolo A, Lazzaretto A, Paci M
107 - 116 Experimental tests and modelization of a domestic-scale ORC (Organic Rankine Cycle)
Bracco R, Clemente S, Micheli D, Reini M
117 - 127 Analysis and optimization of CO2 capture in an existing coal-fired power plant in China
Xu G, Yang YP, Ding J, Li SC, Liu WY, Zhang K
128 - 137 Multicriteria optimization of a distributed energy supply system for an industrial area
Buoro D, Casisi M, De Nardi A, Pinamonti P, Reini M
138 - 146 Energy and exergy analysis of the silicon production process
Takla M, Kamfjord NE, Tveit H, Kjelstrup S
147 - 156 Energetic and exergetic analysis of waste heat recovery systems in the cement industry
Karellas S, Leontaritis AD, Panousis G, Bellos E, Kakaras E
157 - 167 Design of a multipurpose "zero energy consumption" building according to European Directive 2010/31/EU: Architectural and technical plants solutions
Desideri U, Arcioni L, Leonardi D, Cesaretti L, Perugini P, Agabitini E, Evangelisti N
168 - 177 Highly-resolved modeling of personal transportation energy consumption in the United States
Muratori M, Moran MJ, Serra E, Rizzoni G
178 - 184 The LETHE (c) (Low Emissions Turbo-Hybrid Engine) city car of the University of Roma 1: Final proposed configuration
Capata R, Sciubba E
185 - 191 GTL (Gas To Liquid) and RME (Rapeseed Methyl Ester) combustion analysis in a transparent CI (compression ignition) engine by means of IR (infrared) digital imaging
Mancaruso E, Sequino L, Vaglieco BM
192 - 201 How will renewable power generation be affected by climate change? The case of a Metropolitan Region in Northwest Germany
Wachsmuth J, Blohm A, Gossling-Reisemann S, Eickemeier T, Ruth M, Gasper R, Stuhrmann S
202 - 209 Stable and periodic solutions of an exergy-based model of population dynamics
Sciubba E, Zullo F
210 - 219 An experimental exergetic comparison of four different heat pump systems working at same conditions: As air to air, air to water, water to water and water to air
Cakir U, Comakli K, Comakli O, Karsli S
220 - 235 Economic-environmental analysis of handling biogas from sewage sludge digesters in WWTPs (wastewater treatment plants) for energy recovery: Case study of Bekkelaget WWTP in Oslo (Norway)
Venkatesh G, Elmi RA
236 - 246 The fossil trace of CO2 emissions in multi-fuel energy systems
Agudelo A, Valero A, Uson S
247 - 257 Forecasting electricity infeed for distribution system networks: An analysis of the Dutch case
Tanrisever F, Derinkuyu K, Heeren M
258 - 269 Thermal performance of flat plate solar collectors with sheet-and-tube and roll-bond absorbers
Del Col D, Padovan A, Bortolato M, Pre MD, Zambolin E
270 - 282 Mixtures of rubber tyre and plastic wastes pyrolysis: A kinetic study
Miranda M, Cabrita I, Pinto F, Gulyurtlu I
283 - 295 Non-isothermal modeling of a small passive direct methanol fuel cell in vertical operation with anode natural convection effect
Wang LW, Zhang YF, An ZJ, Huang ST, Zhou ZP, Liu XW
296 - 304 A comparative evaluation of physical and chemical properties of biodiesel synthesized from edible and non-edible oils and study on the effect of biodiesel blending
Atabani AE, Mahlia TMI, Masjuki HH, Badruddin IA, Yussof HW, Chong WT, Lee KT
305 - 317 A review of catalysts for the gasification of biomass char, with some reference to coal
Nzihou A, Stanmore B, Sharrock P
318 - 329 GIS-based assessment of the district heating potential in the USA
Gils HC, Cofala J, Wagner F, Schopp W
330 - 339 A study of the rebound effect on China's current energy conservation and emissions reduction: Measures and policy choices
Lin BQ, Yang F, Liu X
340 - 349 The Divisia real energy intensity indices: Evolution and attribution of percent changes in 20 European countries from 1995 to 2010
Gonzalez PF, Landajo M, Presno MJ
350 - 356 Evaluation of self-heating in Miscanthus x giganteus energy crop clamps and the implications for harvesting time
Everard CD, Finnan J, McDonnell KP, Schmidt M
357 - 363 Efficient hydrogenation of biomass-derived furfural and levulinic acid on the facilely synthesized noble-metal-free Cu-Cr catalyst
Yan K, Chen AC
364 - 375 Modeling of micro-CHP (combined heat and power) unit and evaluation of system performance in building application in United States
Lee H, Bush J, Hwang Y, Radermacher R
376 - 383 Effect of residence time on chemical and structural properties of hydrochar obtained by hydrothermal carbonization of water hyacinth
Gao Y, Wang XH, Wang J, Li XP, Cheng JJ, Yang HP, Chen HP
384 - 397 Prediction and verification of the thermodynamic performance of vapor-liquid separation condenser
Hua N, Chen Y, Chen EX, Deng LS, Zheng WX, Yang Z
398 - 403 Experiment and simulation study on the flux distribution of lens-walled compound parabolic concentrator compared with mirror compound parabolic concentrator
Li GQ, Pei G, Su YH, Ji J, Riffat SB
404 - 416 Thermodynamic analysis of a dual loop heat recovery system with trilateral cycle applied to exhaust gases of internal combustion engine for propulsion of the 6800 TEU container ship
Choi BC, Kim YM
417 - 425 Estimation of daily global solar irradiation by coupling ground measurements of bright sunshine hours to satellite imagery
Rusen SE, Hammer A, Akinoglu BG
426 - 437 Development of emission parameters and net energy ratio for renewable diesel from Canola and Camelina
Miller P, Kumar A
438 - 447 Development and comparative analysis of the modeling of an innovative finned-plate latent heat thermal energy storage system
Campos-Celador A, Diarce G, Gonzalez-Pino I, Sala JM
448 - 457 Energy and exergy analyses of a bottoming Rankine cycle for engine exhaust heat recovery
Zhu SP, Deng KY, Qu S
458 - 472 A comparison between exergetic and economic criteria for optimizing the heat recovery steam generators of gas-steam power plants
Carapellucci R, Giordano L
473 - 482 Parametric optimization of regenerative organic Rankine cycle (ORC) for low grade waste heat recovery using genetic algorithm
Xi H, Li MJ, Xu C, He YL
483 - 493 Computational fluid dynamics (CFD) mesh independency techniques for a straight blade vertical axis wind turbine
Almohammadi KM, Ingham DB, Ma L, Pourkashan M
494 - 510 Study of zeotropic mixtures of ORC (organic Rankine cycle) under engine various operating conditions
Yang K, Zhang HG, Wang Z, Zhang J, Yang FB, Wang EH, Yao BF
511 - 518 Performance assessment of different solar photovoltaic technologies under similar outdoor conditions
Sharma V, Kumar A, Sastry OS, Chandel SS
519 - 526 Flexible ruthenium oxide-activated carbon cloth composites prepared by simple electrodeposition methods
Sieben JM, Morallon E, Cazorla-Amoros D
527 - 537 Decentralized combined heat and power production by two-stage biomass gasification and solid oxide fuel cells
Bang-Moller C, Rokni M, Elmegaard B, Ahrenfeldt J, Henriksen UB
538 - 549 Multi-objective optimization of organic Rankine cycles for waste heat recovery: Application in an offshore platform
Pierobon L, Nguyen TV, Larsen U, Haglind F, Elmegaard B
550 - 560 Exergo-sustainability indicators of a turboprop aircraft for the phases of a flight
Aydin H, Turan O, Karakoc TH, Midilli A
561 - 570 Energy and sizing analyses of parabolic trough solar collector integrated with steam and binary vapor cycles
Al-Sulaiman FA
571 - 587 Thermoeconomic design optimization of a thermo-electric energy storage system based on transcritical CO2 cycles
Morandin M, Mercangoz M, Hemrle J, Marechal F, Favrat D
588 - 593 Applying data envelopment analysis approach to improve energy efficiency and reduce GHG (greenhouse gas) emission of wheat production
Khoshnevisan B, Rafiee S, Omid M, Mousazadeh H
594 - 605 Revised Dalton's method for calculation of thermodynamic properties of unsaturated humid air and gas mixture after combustion in humid air turbine cycle
Wang ZD, Chen HP, Weng SL
606 - 616 New calculation method for thermodynamic properties of humid air in humid air turbine cycle - The general model and solutions for saturated humid air
Wang ZD, Chen HP, Weng SL
617 - 627 A systematic laboratory study on an anticorrosive cool coating of oil storage tanks for evaporation loss control and energy conservation
Zhang WD, Song ZN, Song JR, Shi YX, Qu J, Qin J, Zhang T, Li YW, Zhang HQ, Zhang RP
628 - 634 Preparation and properties of highly conductive palmitic acid/graphene oxide composites as thermal energy storage materials
Mehrali M, Latibari ST, Mehrali M, Mahlia TMI, Metselaar HSC
635 - 643 Assessment of energy and economic benefits arising from syngas storage in IGCC power plants
Cocco D, Serra F, Tola V
644 - 654 Packed bed of spherical particles approach for pressure drop prediction in wall-flow DPFs (diesel particulate filters) under soot loading conditions
Serrano JR, Arnau FJ, Piqueras P, Garcia-Afonso O
655 - 663 Modeling and assessment of the efficiency of horizontal and vertical ground heat exchangers
Florides G, Theofanous E, Iosif-Stylianou I, Tassou S, Christodoulides P, Zomeni Z, Tsiolakis E, Kalogirou S, Messaritis V, Pouloupatis P, Panayiotou G
664 - 671 Environmental impact assessment of a turboprop engine with the aid of exergy
Atilgan R, Turan O, Altuntas O, Aydin H, Synylo K
672 - 678 Entropy resistance minimization: An alternative method for heat exchanger analyses
Cheng XT
679 - 687 Thermodynamic efficiency of synthesis, storage and breakdown of the high-energy metabolites by photosynthetic microalgae
Sorguven E, Ozilgen M
688 - 694 Production of low-tar producer gas from air gasification of mixed plastic waste in a two-stage gasifier using olivine combined with activated carbon
Cho MH, Mun TY, Kim JS
695 - 706 Mini-hydro: A design approach in case of torrential rivers
Barelli L, Liucci L, Ottaviano A, Valigi D
707 - 713 The effects of FEC (fluoroethylene carbonate) electrolyte additive on the lithium storage properties of NiO (nickel oxide) nanocuboids
Seng KH, Li L, Chen DP, Chen ZX, Wang XL, Liu HK, Guo ZP
714 - 714 Comments on "Assessment of different methods used to estimate Weibull distribution parameters for wind speed in Zafarana wind farm, Suez Gulf, Egypt"
Awad MM