화학공학소재연구정보센터

Chemical Engineering Research & Design

Chemical Engineering Research & Design, Vol.87, No.12A Entire volume, number list
ISSN: 0263-8762 (Print) 

In this Issue (12 articles)

1567 - 1572 Effects of the inlet section angle on the separation performance of a cyclone
Qian FP, Wu YP
1573 - 1581 Lift and drag forces on an isolated cubic particle in pipe flow
Laskovski D, Stevenson P, Galvin KP
1582 - 1588 A comparison between two kinds of hydrodynamic models in bubble column slurry reactor during Fischer-Tropsch synthesis: Single-bubble class and two-bubble class
Ghasemi S, Sohrabi M, Rahmani M
1589 - 1595 Taking green anti-fouling strategies in dead-end ultrafiltration to the next level
Zondervan E, Bakker S, Nederlof M, Roffel B
1596 - 1603 Sensitivity of pipeline gas flow model to the selection of the equation of state
Chaczykowski M
1604 - 1611 Modeling and experimentation of a novel labyrinth bubble photoreactor for degradation of organic pollutant
Hao XG, Li HH, Zhang ZL, Fan CM, Liu SB, Sun YP
1612 - 1630 Design of ring and spider type spargers for bubble column reactor: Experimental measurements and CFD simulation of flow and weeping
Kulkarni AV, Badgandi SV, Joshi JB
1631 - 1639 Emulsification capability of a dual shaft mixer
Khopkar AR, Fradette L, Tanguy PA
1640 - 1648 Effect of glycerol on the binary coalescence of water drops in stagnant oil phase
Wang W, Gong J, Ngan KH, Angeli P
1649 - 1657 Energy saving and capital cost evaluation in distillation column sequences with a divided wall column
Errico M, Tola G, Rong BG, Demurtas D, Turunen I
1658 - 1666 Internal heat integrated distillation columns (iHIDiCs)-New systematic design methodology
Gadalla MA
1667 - 1671 Mass transfer and concentration contours between an oblate spheroid buried in granular beds and a flowing fluid
Delgado JMPQ, da Silva MV