화학공학소재연구정보센터

Journal of Materials Science

Journal of Materials Science, Vol.46, No.4 Entire volume, number list
ISSN: 0022-2461 (Print) 

In this Issue (38 articles)

855 - 874 Review of the anatase to rutile phase transformation
Hanaor DAH, Sorrell CC
875 - 881 Microstructural evolution of Al-Zn-Mg-Cu alloy during homogenization
Deng YL, Wan L, Wu LH, Zhang YY, Zhang XM
882 - 888 Synthesis and characterization of polyamide-6/graphite oxide nanocomposites
Liu Y, Chen ZM, Yang GS
889 - 895 Study of interdiffusion and growth of topologically closed packed phases in the Co-Nb system
Balam SSK, Paul A
896 - 901 Study on electrical transport and photoconductivity in iodine-doped cellulose fibers
Zakirov AS, Yuldashev SU, Wang HJ, Lee JC, Kang TW, Mamadalimov AT
902 - 909 Reactive sintering mechanism of Ti + Mo2C and Ti + VC powder compacts
Liu YB, Liu Y, Tang HP, Wang B, Liu B
910 - 922 Synthesis and structural characterization of Fe3+-doped calcium hydroxyapatites: role of precursors and synthesis method
Salviulo G, Bettinelli M, Russo U, Speghini A, Nodari L
923 - 930 Poly(adipic acid-hexamethylene diamine)-functionalized multi-walled carbon nanotube nanocomposites
Zhang XX, Meng QJ, Wang XC, Bai SH
931 - 937 Two-step template-free route for synthesis of TiO2 hollow spheres
Zhu ZF, He ZL, Li JQ, Zhou JQ, Wei N, Liu DG
938 - 950 Analyses of deformation twinning in the extruded magnesium alloy AZ31 after compressive and cyclic loading
Huppmann M, Lentz M, Chedid S, Reimers W
951 - 956 Influence of melt temperature on the compressive plasticity of a Zr-Cu-Ni-Al-Nb bulk metallic glass
Zeng XR, Xie SH, Hu QA, Fu DJ, Qian HX, Fu MW
957 - 963 Microstructure and mechanical properties of high boron white cast iron with about 4 wt% chromium
Chen XA, Li YX, Zhang HM
964 - 974 Influence of cold remote nitrogen oxygen plasma treatment on carbon fabric and its composites with specialty polymers
Tiwari S, Sharma M, Panier S, Mutel B, Mitschang P, Bijwe J
975 - 982 Pyrolytic formation of a carbonaceous solid for heavy metal adsorption
Bourlinos AB, Karakassides MA, Stathi P, Deligiannakis Y, Zboril R, Dallas P, Steriotis TA, Stubos AK, Trapalis C
983 - 991 Influence of fibre orientation on three-body abrasive wear behaviour of unidirectional carbon fibre-reinforced polyetherimide composite
Harsha AP, Arjula S
992 - 998 Synthesis and characterization of Rosebengal/folicacid-functionalized multiwall carbon nanotubes
Anbarasan R, Peng CA
999 - 1006 Influence of sintering atmosphere on the microstructure and water durability of SnO-MgO-P2O5 glass
Shyu JJ, Yeh CH
1007 - 1014 Electronic, elastic and optical properties on the Zn1-xMgxSe mixed alloys
Surucu G, Colakoglu K, Deligoz E, Ciftci Y, Korozlu N
1015 - 1020 Structural, optical, and electrical characteristics of 70 Mev Si5+ ion irradiation-induced nanoclusters of gallium nitride
Suresh S, Ganesh V, Deshpande UP, Shripathi T, Asokan K, Kanjilal D, Baskar K
1021 - 1026 Methylthiolate adsorbed on as-rich GaAs (001) surface
Gao W, Zhu SE, Zhao M
1027 - 1037 FP-LAPW calculations of structural, electronic, and optical properties of alkali metal tellurides: M2Te [M: Li, Na, K and Rb]
Alay-E-Abbas SM, Shaukat A
1038 - 1043 Luminescence and EPR studies of Y2O3:Gd3+ phosphors prepared via solution combustion method
Singh V, Chakradhar RPS, Rao JL, Ledoux-Rak I, Kwak HY
1044 - 1048 The materials characteristic and the efficiency degradation of solar cells from solar grade silicon from a metallurgical process route
Yang H, Wang H
1049 - 1052 Novel route to polyaniline nanofibers from miniemulsion polymerization
Wang H, Wang L, Wang RX, Tian XY
1053 - 1057 Temperature dependence of ferroelectric and dielectric properties of textured 0.98(0.94Na(0.5)Bi(0.5)TiO(3)-0.06BaTiO(3))-0.02K(0.5)Na(0.5)NbO(3) thick film
Fu F, Zhai JW, Xu ZK, Ye CG, Yao X
1058 - 1075 Influences of Si and Mg contents on microstructures of Al-xSi-yMg functionally gradient composites reinforced with in situ primary Si and Mg2Si particles by centrifugal casting
Lin XD, Liu CM, Zhai YB, Wang K
1076 - 1082 Recrystallization behaviors of alloy IC10 at elevated temperature: experiments and modeling
Zhang HJ, Wen WD, Cui HT, Xu Y
1083 - 1086 Measurement of mechanical properties of 1045 steel with significant pile-up by sharp indentation
Zhu LN, Xu BS, Wang HD, Wang CB, Yang DX
1087 - 1094 A dislocation-based constitutive description of strain-rate effect on the deformation resistance of metals
Cai MC, Shi HJ, Yu T
1095 - 1102 Structural and dielectric properties of Li2O-ZnO-BaO-B2O3-CuO glasses
Salem SM, Antar EM, Mohamed EA
1103 - 1109 Influence of N and Fe on alpha-Ti precipitation in the in situ TiC-titanium alloy composites
Amirthan G, Nakao K, Balasubramanian M, Tsuda H, Mori S
1110 - 1123 Effect of aspect ratio on large deformation and necking of polyethylene
Muhammad S, Jar PYB
1124 - 1131 Effects of annealing treatment on the ratcheting behavior of extruded AZ31B magnesium alloy under asymmetrical uniaxial cyclic loading
Zhang XP, Castagne S, Gu CF, Luo XF
1132 - 1135 Increasing the thermal diffusivity of flexible graphite sheets by superheated steam treatment
Kitaoka S, Wada M, Nagai T, Osa N, Konno T
1136 - 1138 Direct hydrothermal electrochemical preparation of diamond-like carbon films on substrates
Tao Y, Yi DQ, Zhu BJ, Wang DN, Wang ZY, He KC
1139 - 1142 An easy method for manufacture of gold nanoparticles on a glassy carbon surface
Zhou YL, Zheng X, Wu LZ, Zhi JF, Xu MT
1143 - 1146 Properties of multi-walled carbon nanotube reinforced carbon foam composites
Li WQ, Zhang HB, Xiong XA
1147 - 1152 The study on a mixed-phase I-N-TiO2 for the treatment of azithromycin wastewater under visible light
Qian XW, Zhang N, Xu MX, Chen C