화학공학소재연구정보센터

Journal of Aerosol Science

Journal of Aerosol Science, Vol.113 Entire volume, number list
ISSN: 0021-8502 (Print) 

In this Issue (25 articles)

1 - 11 Impact of aggressive drive cycles on motor vehicle exhaust PM emissions
Maricq MM, Szente JJ, Harwell AL, Loos MJ
12 - 19 Performance evaluation of conventional type conductive cooling continuous flow compact water-based CPC (Hy-WCPC)
Hwang I, Ahn KH
20 - 35 On the impact of DPF downsizing and cellular geometry on filtration efficiency in pre- and post-turbine placement
Serrano JR, Bermudez V, Piqueras P, Angiolini E
36 - 39 On the growth rate of particle surface area for Brownian coagulation
Xie ML
40 - 51 Application of the TheRmophoretic Annular Precipitator (TRAP) for the study of soot aggregates morphological influence on their thermophoretic behaviour
Yahia LAA, Gehin E, Sagot B
52 - 70 Deposition fraction of ellipsoidal fibers in a model of human nasal cavity for laminar and turbulent flows
Tavakol MM, Ghahramani E, Abouali O, Yaghoubi M, Ahmadi G
71 - 84 Thermophoresis of a spherical particle in a microtube
Li CY, Keh HJ
85 - 94 Investigation of alternative metrics to quantify PM mass emissions from light duty vehicles
Xue J, Li Y, Quiros D, Hu SH, Huai T, Ayala A, Jung HSJ
95 - 107 Impact of drought and normal monsoon scenarios on aerosol induced radiative forcing and atmospheric heating in Varanasi over middle Indo-Gangetic Plain
Kumar M, Raju MP, Singh RS, Banerjee T
108 - 113 Paper-based electrospray emitters
Zhao XY, Li C, Yang WW, Deng WW
114 - 118 Investigation on the photophoretic lift force acting upon particles under light irradiation
Dong SL, Liu YF
119 - 129 A Fast Integrated Mobility Spectrometer for rapid measurement of sub-micrometer aerosol size distribution, Part II: Experimental characterization
Wang J, Pikridas M, Pinterich T, Spielman SR, Tsang T, McMahon A, Smith S
130 - 140 Porosity and shape of airborne wear microparticles generated by sliding contact between a low-metallic friction material and a cast iron
Nosko O, Borrajo-Pelaez R, Hedstrom P, Olofsson U
141 - 152 Absorption of chemically aged biomass burning carbonaceous aerosol
Tasoglou A, Saliba G, Subramanian R, Pandis SN
153 - 165 Monitoring particle emission for non-road diesel machineries equipped with particulate filters
Bemer D, Subra I
166 - 177 Particulate matter emission characteristics of a reactivity controlled compression ignition engine fueled with biogas/diesel dual fuel
Qian Y, Zhang YH, Wang XL, Lu XC
178 - 188 Nonequilibrium ionization of welding fume plasmas; Effect of potassium additional agent on the particle formation
Vishnyakov VI, Kiro SA, Oprya MV, Shvets OI, Ennan AA
189 - 200 Human nasal olfactory deposition of inhaled nanoparticles at low to moderate breathing rate
Tian L, Shang YD, Dong JL, Inthavong K, Tu JY
201 - 211 Controlled nanoparticle synthesis via opposite-polarity electrospray pyrolysis
Tang J, Wang HL, Gomez A
212 - 226 Aerosol dynamics model for the simulation of hygroscopic growth and deposition of inhaled NaCl particles in the human respiratory tract
Winkler-Heil R, Pichelstorfer L, Hofmann W
227 - 241 A mathematical model to predict the effect of electrospinning processing parameters on the morphological characteristic of nano-fibrous web and associated filtration efficiency
Ismail N, Maksoud FJ, Ghaddar N, Ghali K, Tehrani-Bagha A
242 - 249 Chemical composition of radiolytically formed particles using single-particle mass spectrometry
Wonaschuetz A, Kallinger P, Szymanski W, Hitzenberger R
250 - 264 Experimental investigation of the effect of inlet particle properties on the capture efficiency in an exhaust particulate filter
Viswanathan S, Rothamer D, Zelenyuk A, Stewart M, Bell D
265 - 275 Expanded flow rate range of high-resolution nanoDMAs via improved sample flow injection at the aerosol inlet slit
de la Mora JF
276 - 276 Surface area is the biologically most effective dose metric for acute nanoparticle toxicity in the lung (vol 99, pg 133, 2016)
Schmid O, Stoeger T