화학공학소재연구정보센터

International Polymer Processing

International Polymer Processing, Vol.22, No.2 Entire volume, number list
ISSN: 0930-777X (Print) 

In this Issue (12 articles)

122 - 131 Functionalization of low density polyethylene with ricinol-2-oxazoline methyl maleate in a twin-screw extruder
Jeziorska R
132 - 139 Modelling of phase transitions and residual thermal stress of CTBN rubber modified epoxy resins during a pultrusion process
Calabrese L, Valenza A
140 - 145 Real-time diagnosis of micro powder injection molding using integrated ultrasonic sensors
Cheng CC, Ono Y, Whiteside BD, Brown EC, Jen CK, Coates PD
146 - 150 Rheological behavior of HEUR mixtures in aqueous media
Barmar M, Kaffashi B
151 - 154 Spinnability and dyeability for copolymer/nano-SiO2 fiber of glycol and 1,2-propanediol with PTA
Wu J, Chen Y, Li Z, Li S
155 - 165 Development of a novel transcription molding process to fabricate sophisticated polymer products with precise microstructure and high transparency applicable to display devices and bio-chips
Ito H, Satoh I, Saito T, Yakemoto K
166 - 172 Effect of aspect ratio of whisker on the fibrillation of liquid crystalline polymer in polysulfone matrix
Chen J, Chen P, Wu L, Zhang J, He J
173 - 178 Gas assisted injection molding of an industrial part: 3D simulation provides virtual molding trials
Polynkin A, Pittman JFT, Sienz J
179 - 189 Analysis of film blowing with flow-enhanced crystallization - Part 1. Steady-state behavior
Henrichsen LK, McHugh AJ
190 - 197 Analysis of film blowing with flow-enhanced crystallization - Part 2. Linearized sensitivity and stability behavior
Henrichsen LK, McHugh AJ
198 - 203 A composite model for melting, pressure and fill factor profiles in a metered fed closely intermeshing counter-rotating twin screw extruder
Wilczynski K, Jiang Q, White JL
204 - 212 Surface defects of TPO injected foam parts for automotive applications
Santoni A, Guo MC, Heuzey MC, Carreau PJ