114 - 114 |
Pioneering polymer industry developments: Bayer and the first synthetic rubber White JL |
115 - 121 |
Modeling non-isothermal mixing in a rotor mixer Malkin AY, Baranov AV, Balinov AI |
122 - 127 |
Chrome nitride coatings for applications in plastics processing Berg G, Friedrich C, Broszeit E, Cremer M |
128 - 135 |
Using computational fluid dynamics to investigate the flow of a viscous fluid in a cavity with oscillating boundaries Overd MM, Generalis SC |
136 - 143 |
Simulation of flow in an intermeshing modular counter-rotating twin screw extruder: Non-Newtonian and non-isothermal behavior Hong MH, White JL |
144 - 151 |
Bulk and dispersed phase polymerization of urethane in twin screw extruders Cassagnau P, Nietsch T, Michel A |
152 - 158 |
Wire coating by drawdown of an extruded annular melt Slattery JC, Giacomin AJ, Ding F |
159 - 167 |
Structure development in melt spinning polypropylene-EPM blends and dynamically vulcanized polyolefin TPEs Yu Y, White JL |
168 - 174 |
Simulation of blown-film process taking account of cooling-air effect Akaike O, Tsuji T, Nagano Y |
175 - 182 |
Advances in on-line monitoring of the injection molding process using ultrasonic techniques Wen SSL, Jen CK, Nguyen KT |
183 - 190 |
Analysis of shrinkage development of injection moulded PS samples Pantani R, Titomanlio G |
191 - 195 |
Optimization of the welding strength in gas-assist injection molded thermoplastic Liu SJ, Ho CY, Chang JH, Hung SW |
196 - 204 |
Injection velocity control using a self-tuning adaptive controller Yang Y, Gao F |