화학공학소재연구정보센터
검색결과 : 78건
No. Article
1 Injection moulding of porous MAX phase Ti3SiC2 without using space-holder
Tabares E, Cifuentes SC, Jimenez-Morales A, Tsipas SA
Powder Technology, 380, 96, 2021
2 Molding properties of titanium-based feedstock used in low-pressure powder injection molding
Ghanmi O, Demers V
Powder Technology, 379, 515, 2021
3 Fabrication of titanium components by low-pressure powder injection moulding using hydride-dehydride titanium powder
Moghadam MS, Fayyaz A, Ardestani M
Powder Technology, 377, 70, 2021
4 Numerical simulation and experimental investigation of mold filling and segregation in low-pressure powder injection molding of metallic feedstock
Ben Trad MA, Demers V, Cote R, Sardarian M, Dufresne L
Advanced Powder Technology, 31(3), 1349, 2020
5 Effect of 17-4PH stainless steel powders interaction on feedstocks
Ma HH, Li S, Jin ZS, Tian YW, Ren FM, Zhou ZF, Xu WB
Powder Technology, 372, 204, 2020
6 Investigation and two-stage modeling of sintering behavior of nano/micro-bimodal powders
Oh JW, Seong Y, Shin D, Park SJ
Powder Technology, 352, 42, 2019
7 Optimizing hydride-dehydride Ti-6Al-4V feedstock composition for titanium powder injection moulding
Thavanayagam G, Swan JE
Powder Technology, 355, 688, 2019
8 Experimental study on moldability and segregation of Inconel 718 feedstocks used in low-pressure powder injection molding
Demers V, Fareh F, Turenne S, Demarquette NR, Scalzo O
Advanced Powder Technology, 29(1), 180, 2018
9 Effect of binder composition on rheological behavior of PMN-PZT ceramic feedstock
Park JM, Han JS, Gal CW, Oh JW, Kate KH, Atre SV, Kim Y, Park SJ
Powder Technology, 330, 19, 2018
10 Powder distribution on powder injection moulding of ceramic green compacts using thermogravimetric analysis and differential scanning calorimetry
Poh L, Della C, Ying SJ, Goh C, Li Y
Powder Technology, 328, 256, 2018