Process Intensification: Higee Seawater Deaeration

https://doi.org/10.1205/026387698525261Get rights and content

The background to the development of a rotating packed bed (Higee) deaerator is described. Early experiments with single bubbles were followed by visualization tests involving a stationary tower with trays of knitted mesh ‘bubble choppers’. A rotating system was then designed and operated to exploit the high buoyancy forces which could be generated, and some results are presented. Very high hydraulic capacities can be achieved, so that a 400RPM rotor capable of treating 500 m3/hr of freshwater and giving 4 transfer units, is ultimately expected to be only 1 m diameter and 1.0 m long. If backmixing can be suppressed then even higher mass transfer duties can be reached.

References (8)

There are more references available in the full text version of this article.

Cited by (63)

  • Improving liquid distribution in a rotating packed bed

    2020, Chemical Engineering and Processing - Process Intensification
    Citation Excerpt :

    Moreover, crossflow has a lower contacting efficiency than counter-current flow. RPBs with split packing enable both redistribution of the liquid at regular intervals, which limits the formation of dry spots, and cross-current flow [45–,1–47]. Unfortunately, their mechanical construction is rather complex construction-wise, they mainly improve the gas-side resistance controlled mass transfer processes and they can only operate as single stage [13].

  • A guide on the industrial application of rotating packed beds

    2018, Chemical Engineering Research and Design
    Citation Excerpt :

    Although the reactive absorption of CO2 for post-combustion capture is subject of many research works published in the recent literature and was summarised in detail by comprehensive reviews (Pan et al., 2017; Wang et al., 2011, 2015; Zhao et al., 2016), no implementation on an industrial scale has been reported yet. Industrial scale deaeration of liquids, primarily water, is performed for a variety of reasons: corrosion prevention for boiler feed water and piping systems (Revie and Uhlig, 2008), increased shelf-life and avoidance of biological contamination, blockage of oil bearing rock (Peel et al., 1998), increasing bottling speeds in the beverage industry (Harbold and Park, 2008). For the latter, the deaeration allows for a reduction of waste through overflowing bottles, as well as an improved filling level and carbonation control of the final products (Harbold and Park, 2008).

View all citing articles on Scopus
View full text