Skip to main content
Log in

Fractal approach to the critical filler volume fraction of an electrically conductive polymer composite

  • Papers
  • Published:
Journal of Materials Science Aims and scope Submit manuscript

Abstract

It has been known for quite a long time that polymers filled with electrically conductive particles, foils or fibres exhibit a distinctive dependence of conductivity on filler volume fraction. With a rise in filler content, there is always a drastic increase in composite conductivity by the order of ten magnitudes at a certain threshold, namely, the critical volume fraction. Such a transition-like change in conductivity is usually interpreted as percolation. Many models have been proposed for explaining the conduction mechanism involved, but often they possess evident drawbacks mainly due to the negligence of relative filler arrangements or the Euclidean geometric description of the arrays. The present work focused on the prediction of the critical volume fraction by a new electrical conductive model, based on the fractal technique and the generalized unit-cell method proposed by Pitchumani and Yao for modelling the thermal conductivity of fibrous composites. It was found that the electrical conduction behaviour of a polymer composite is governed by both a filler geometry factor and a material factor of the components. The critical volume fractions estimated by the model are in good agreement with experimental results taken from the literature. In addition, possible improvements of the present approach are discussed.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  1. R. A. Crossman, Polym. Eng. Sci. 25 (1985) 507.

    Article  CAS  Google Scholar 

  2. J. M. Margolis, “Conductive Polymers and Plastics” (Chapman and Hall, New York, 1989).

    Google Scholar 

  3. J. M. Crosby and J. E. Travis, Rubber World 11 (1985) 30.

    Google Scholar 

  4. M. Q. Zhang, PhD thesis, Zhongshan University, Guangzhou, People's Republic of China (1991).

    Google Scholar 

  5. F. Lux, J. Mater. Sci. 28 (1993) 285.

    Article  CAS  Google Scholar 

  6. S. Kirkpatrick, Rev. Mod. Phys. 45 (1973) 574.

    Article  Google Scholar 

  7. R. Zallen, “The Physics of Amorphous Solids” (Wiley, New York, 1983).

    Google Scholar 

  8. C. C. Chen and Y. C. Chou, Phys. Rev. Lett. 54 (1985) 2529.

    CAS  Google Scholar 

  9. G. R. Ruschau and R. E. Newnham, J. Compos. Mater. 26 (1992) 2727.

    CAS  Google Scholar 

  10. K. Miyasaka, K. Watanabe, E. Jojima, H. Aida, M. Sumita and K. Ishikawa, J. Mater. Sci. 17 (1982) 1610.

    Article  CAS  Google Scholar 

  11. M. Sumita, H. Abe, H. Kayaki and K. Miyasaka, J. Macromol. Sci. Phys. B25 (1986) 171.

    Google Scholar 

  12. R. Pitchumani and S. C. Yao, J. Heat Transfer 113 (1991) 788.

    CAS  Google Scholar 

  13. B. B. Mandelbrot, “The Fractal Geometry of Nature” (Freeman, New York, 1983).

    Google Scholar 

  14. E. Hornborgen, Int. Mater. Rev. 34 (1989) 277.

    Google Scholar 

  15. C. Kittel, “Introduction to Solid State Physics” (Wiley, New York, 1986).

    Google Scholar 

  16. G. R. Ruschau, S. Yoshikawa and R. E. Newnham, Int. J. Hybrid Microelectron. 13 (1990) 100.

    Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Rights and permissions

Reprints and permissions

About this article

Cite this article

Zhang, M.Q., Xu, J.R., Zeng, H.M. et al. Fractal approach to the critical filler volume fraction of an electrically conductive polymer composite. JOURNAL OF MATERIALS SCIENCE 30, 4226–4232 (1995). https://doi.org/10.1007/BF00361501

Download citation

  • Received:

  • Accepted:

  • Issue Date:

  • DOI: https://doi.org/10.1007/BF00361501

Keywords

Navigation