Separation Characteristics of Ternary Gas Mixtures in Serial Cells of Polysulfone Hollow Fibre Membranes

https://doi.org/10.1205/026387699526377Get rights and content

Separation characteristics of CO2, O2, and N2 gas mixtures are measured in a series configuration of hollow fibre polysulfone membranes. One, two, and three separation cells in series are used in the experiments and are operated in the counter current mode. The measurements are performed as a function of the reject flow rate and pressure. Measured data are compared against predictions of the countercurrent flow model. Measurements and analyses include variations in the stage cut as well as species permeance, removal, recovery, permeate enrichment, and reject depletion. Measurements and model predictions are closely matched with percentage errors of less than 10%. Operation with three cells in series results in larger stage cuts and higher species recovery in the permeate stream. This is associated with lower purity in the permeate and reject streams. The highest permeate enrichment is found for the permeate stream in the first cell for the two and three cells system. This is caused by the constant reject flow used in various configurations. As a result, higher feed flow rates are used for the two and three cells in series, which reduces the gas residence time in the first cell and makes separation more selective.

References (30)

Cited by (12)

  • Preparation and characterization of low temperature PTFE-Nafion composite membranes for hydrogen production

    2015, International Journal of Hydrogen Energy
    Citation Excerpt :

    The separation factor (α) is the ability of the membrane to filter out unwanted gases and allow the desired gas to pass through or vice versa, whereas the permeability (P) is the flow rate of a component in the gas mixture through the membrane or the flux of a specific gas through the membrane. Three additional important parameters are the permeation flux (J); the selectivity (β), which is equal to separation factor [14]; and the permeance (P/l), which is the ratio of the permeability to the effective thickness of the membrane [15,16]. The dominant gas transport mechanisms in the membranes depend on the size of the pores.

  • Hollow fiber membrane process for the pretreatment of methane hydrate from landfill gas

    2014, Fuel Processing Technology
    Citation Excerpt :

    Then, the rapid evaporation of methanol left small amount of water in the pores before the fiber was dried. It may cause the fibers to quick shrinkage [27,28]. However, the selectivity of KM2 is lower than that of KM1 as shown in the Fig. 5(b).

  • Separation of sulfur hexafluoride (SF<inf>6</inf>) from ternary gas mixtures using commercial polysulfone (PSf) hollow fiber membranes

    2014, Journal of Membrane Science
    Citation Excerpt :

    With increase in feed pressure from 1×105 Pa to 7×105 Pa by an increment of 2×105 Pa, the flow rate in the feed, permeate and retentate sides linearly increases at a rate of 7.9×10−4, 4.8×10−4 and 3.1×10−4 cm3/min/Pa/min/bar, respectively (see Fig. 6(a)). This observation suggests that the treatment and production capacity of the membrane can be increased with an increase in the feed pressure [22]. Fig. 6(b) shows the permeances and the selectivities of the ternary gas mixture as a function of feed pressure.

  • Separation performance of PEBAX/PEI hollow fiber composite membrane for SO<inf>2</inf>/CO<inf>2</inf>/N<inf>2</inf> mixed gas

    2013, Chemical Engineering Journal
    Citation Excerpt :

    The stage cut significantly impacts the gas permeation properties. Consequently, insufficient time is available for the species to permeate within the membrane, and the separation thus becomes more selective [45]. A higher stage cut results in higher permeation by SO2 due to an increase in the driving force.

View all citing articles on Scopus
View full text