Elsevier

Polymer

Volume 37, Issue 23, November 1996, Pages 5139-5149
Polymer

Polymer paper
Effect of chemical treatment on the tensile properties of short sisal fibre-reinforced polyethylene composites

https://doi.org/10.1016/0032-3861(96)00144-9Get rights and content

Abstract

The effect of chemical treatment on the tensile properties of sisal fibre-reinforced LDPE (low density polyethylene) composites was investigated. Treatments using chemicals such as sodium hydroxide, isocyanate, permanganate and peroxide were carried out to improve the bonding at the fibre polymer interface. The treatments enhanced the tensile properties of the composites considerably, but to varying degrees. The SEM (scanning electron microscopy) photomicrographs of fracture surfaces of the treated composites clearly indicated the extent of fibre matrix interface adhesion. It has been demonstrated that the CTDIC (cardanol derivative of toluene diisocyanate) treatment reduced the hydrophilic nature of the sisal fibre and thereby enhanced the tensile properties of the sisal LDPE composites. The SEM photomicrographs of the fracture surfaces have also shown that PE was highly bonded to the sisal fibre in CTDIC treated composites. The observed enhancement in tensile properties with the addition of small amounts of peroxides was attributed to the peroxide induced grafting of PE on to sisal fibre surfaces, as evident from the SEM photomicrographs of the fracture surfaces. It has been found that a low concentration of permanganate in the sisal-LDPE system during mixing considerably enhanced the mechanical properties. Among the various treatments, peroxide treatment of fibre imparted maximum interfacial interactions.

References (41)

  • E.T.N. Bisanda et al.

    Comp. Sci. Technol.

    (1991)
  • Y.H. Zang et al.

    Polymer

    (1991)
  • K. Joseph et al.

    Mater. Lett.

    (1992)
  • D. Maldas et al.

    Polymer

    (1988)
  • J.P. Pillot et al.

    Eur. Polym. J.

    (1989)
  • K. Joseph et al.

    Comp. Sci. Technol.

    (1995)
  • M.J. Folkes

    Short Fibre Reinforced Thermoplastics

    (1982)
  • G.L. Lightsey

    Organic Fillers for Thermoplastics

  • D. Maldas et al.

    J. Comp. Mater.

    (1991)
  • L.J. Broutman et al.
  • S.V. Prasad et al.

    J. Mater. Sci.

    (1983)
  • D.S. Varma et al.

    Text. Res. J.

    (1984)
  • D.S. Varma et al.

    J. Reinf. Plast. Comp.

    (1985)
  • D.S. Varma et al.

    J. Polym. Mater.

    (1986)
  • I.K. Varma et al.

    Text. Res. J.

    (1988)
  • I.K. Varma et al.

    Text. Res. J.

    (1988)
  • A.D. Beshay et al.

    Polym. Comp.

    (1985)
  • R.G. Raj et al.

    J. Adhes. Sci. Technol.

    (1989)
  • R.G. Raj et al.

    Plast. Rubb. Process Appl.

    (1989)
  • R.G. Raj et al.

    J. Appl. Polym. Sci.

    (1989)
  • Cited by (0)

    Present address: Department of Chemistry, St. Berchmans' College, Changanacherry-686 101, Kerala, India

    View full text